Post Reply 
 
Thread Rating:
  • 0 Votes - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5
CC-43 The End Class Heavy Cruiser [Help Needed!]
2017-10-14, 09:03 PM
Post: #1
CC-43 The End Class Heavy Cruiser [Help Needed!]
[Image: YZmtMMq.jpg]

Inned some help keeping this thing floating and stopping it from becoming a failed plane and submarine(Jumping&Diving in&out of the water.)
This cruiser is the 43rd to be built by the empire and feature many AA guns.
You'll need the following mods:
Deco+
AC V1.2.3 & Raillings V1.1.1
And
Turret Heads

Any feedback/opinion would be helpful.


Attached File(s)
.blueprint  CC-43 The End Class Heavy Cruiser.blueprint (Size: 836.07 KB / Downloads: 8)

"Anata no soba de! " - Hearts of Iron phrase.
Find all posts by this user
Quote this message in a reply
2017-10-14, 10:34 PM
Post: #2
RE: CC-43 The End Class Heavy Cruiser [Help Needed!]
I'm starting to have a look at this baby; I don't have the mods, but at first look I'd say it's in need of segregation of inner space with one air pump per compartment. Unless, of course, subject mods modify also air pumps and some structural blocs, but if it was the case they would still appear as wood blocks. So my first advise would be to segregate that huge inner volume and fit pumps.

Second, it can be "jumping" due to the propeller force being applied far bellow center of gravity (which is very hihg there): it can cause the vessel to nose up under the thrust, then dive down again when too much hull is out of water. One solution can be to fit shaft and propellers on spinblocks, and adjust angle via ACB until trim while underway is 0.
Find all posts by this user
Quote this message in a reply
Post Reply 


Forum Jump:


User(s) browsing this thread: 1 Guest(s)