Post Reply 
 
Thread Rating:
  • 0 Votes - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5
I think I finally 'get' inline turbo's.... somewhat
2018-07-09, 04:22 AM (This post was last modified: 2018-07-09 01:29 PM by Greyfell.)
Post: #1
Wink I think I finally 'get' inline turbo's.... somewhat
Below is a recent attempt to make a pretty simplistic inline turbo engine. Don't ask what iteration of the prototype it is....

3H x 5W x Y long. Staggered flat rows of cylinders with a single carb each, exhaust piped along the bottom, wrapped around the end, and then daisy chained back through the individual turbo's one at a time.

Notes:

1) There's a gap in the bottom middle that's totally empty. That indicates to me there might be a better pattern?

2) Much in the same vein, I basically stuck Superchargers into gaps wherever they fit and stayed within the 3 x 5 dimensions, starting with the spots where more then one carb could make use of them. I know that Super's aren't THAT amazing, except at low RPM, but it's what I could fit.

All thoughts and constructive feedback/criticism welcome.

Stats, as requested: 1000 overall power.
At 100% rpm, it's getting 382 power per fuel (2.6 per second).
at 50% rpm, it's getting 450 PPF, consuming 1.1 fuel per second.
at 10% RPM, it goes to 492 PPF, at 0.2 per second fuel used


Attached File(s) Thumbnail(s)
           

.blueprint  simple inline turbo engine.blueprint (Size: 59.88 KB / Downloads: 2)
.blueprint  simple inline modded by killshoot.blueprint (Size: 60.19 KB / Downloads: 2)

********************************
(Is in your ship, stealing your turrets!)

Mods/extra blocks

After Cataclysm (and the separate 'railings' mod as well)
Dynamic Kinetics Simple Re-skin (armored glass)
Wrought Iron Armor
Structural Foam
Aero-alloy
More Corners 0.3
Find all posts by this user
Quote this message in a reply
Post Reply 


Messages In This Thread
I think I finally 'get' inline turbo's.... somewhat - Greyfell - 2018-07-09 04:22 AM

Forum Jump:


User(s) browsing this thread: 1 Guest(s)